Go here for pics:
http://www.boostcruising.com/forums/...owtopic=233095 (http://www.boostcruising.com/forums/index.php?showtopic=233095)
Okay, need this stuff gone. Here are the parts for sale:
1. 3EM Manual ECU with HP3 Chip to suit cam below, cost me $500.(New programs cost $100 from Chiptorque). Also will throw in the Airflow meter that it was tuned too.
Stage 3 re-grind cam (70/30, 283deg), plus machined lifter cradles (30 thou), and genuine used nissan lifters - $300 (My old vl made 114.5rwkw with this cam, a chip and exhaust. Have dyno sheet to prove.) SOLD
3. 2/1/2 inch turbo catback exhaust, comes with mandrel bends, straight thru muffles and 3" stainless dump tip. I think its actually a redback system (off e-bay) but has had the first muffler replaced with a stainless steel straight thru SuperCat muffler. Ideally suited for Turbo. $100.
4. Cast iron nissan headers plus the engine pipe $30. (VGC) If you buy this I will throw in a 2/1/4 inch cat back exhaust for free.
5. Polished Holden rocked cover $20. In average condition. Could do with a re-polish or else paint it red like the Turbo ones. SOLD
6. Calais side skirts x4, complete in VGC. Comes with most of the clips. $50.
7. XF TB 68mm adapted to VL ported plenum. Plenum has also been bored out to 68mm. Comes with 3inch stainless intake pipe, shortened throttle cable and calibrated TPS and bracket. Cost around $400, will sell for $200 . Gives good power gains.
Will only sell in the Brisbane area. Pickup during the week at my workplace in Virginia (Nth Brissy) is preferrable. Private Message me with any interest.
Cheers,
Joel.
mate I'll grab these bits off you.
1. 68mm XF TB series 2 with ported top inlet manifold to 68mm and a calibrated VL TPS and bracket. (All work done by JHH performance engineering in Woodridge). Also comes with 3" stainless intake pipe (Has been HPC coated and wrapped in reflective tape) and an original VL throttle cable that has been shortened. $100. (Gives most NA motors easy 10rwkw over entire rev range.)
http://www.calaisturbo.com.au/attach...6&d=1084847006
and
5. Polished Holden rocked cover $20.
