what are the rules for qldsc? can any car with a 1/2JZ enter?

Yeah any car I think there's only about 5spots left or something Prizes are only for members tho but there's a few non members cars going

Crankshaft got my pins today Engine gets delivered 2moro ready to be cleaned and assembled

Quote: Originally Posted by calais25t [View Post] Im not aguing, I agree, but how do explain the brake lights only at the end? Id say it has a switch to cut off the brake lights....

Added some pics and an update to the 1st post Built motor almost ready to go in I'm very tempted to send my head off and get it fully done but don't have enough spare coin lol

c'mon moneybags..lol i can't be bothered reading thread again..its a 4 inch exhaust?, if so where did you get the fart cannon from in 4 inch? cheers darren

Nah daz It's a 5" with burns muffler Bought it off the us supra forums Paid about 600us for it I think and had him send it to Sean at Titan and he sent it over It should be all finished and back in the car and ready to tune by next weekend

**** know how you will drive that without earmuffs, i might be getting old, but i have a 3 inch exhaust with one RSR exmag gt2 fartcannon on my stagea and after 30 minutes i have a cracking headache, i havn't even de-catted it yet..lol cheers darren

Yes it is damn loud! And has a big lump like an 8 with the gsc cams It's 5" straight off the turbo, all thinwall stainless and only the 1 muffler at the end so it gets pretty droney Sounds awesome tho and has helped the whole setup ALOT! This turbo comes on faster than my old 76gts with .96 and 1.15 housings and this is a 1.28rear gt45 basically

Cool, i looked up and found the Burns website..going to get a 4 inch fart cannon for the 31, but will probally run another 4 inch straight through aswell..i like noise its the resonance drone that kills me.. 5 inch sounds overkill, haha cheers darren

Yeah 5" is overkill Don't need bigger than 4" till over 1400whp according to full race But I couldn't have built a 4" system for the price I paid for the 5"

what sort of rpms are you seeing decent boost on the road?

No idea yet on this setup Motor is nearly finished so should find out soon

Quote: Originally Posted by TroyVK [View Post] Yeah 5" is overkill Don't need bigger than 4" till over 1400whp according to full race But I couldn't have built a 4" system for the price I paid for the 5" Is that wastegate plumbed back in or screamer?

Both gate are screamers ---------- Post added 24-04-12 at 20:42 ---------- The 1400whp dyno jet figure would have to be screamers aswell I'd say ---------- Post added 24-04-12 at 21:36 ---------- Bit of a set back 2day but hopefully have it sorted by 2moro

Set back all sorted, new cams should arrive 2moro That should hopefully mean the motor goes back in on Sunday arvo ready to run in and tune

lol at calais 25T..i remember seeing that at the cinemas, and now i have the song in my head ****er.. cheers darren

Well another set back today Turns out the piece of metal in the head was a broken piece of valve guide And some bent valve in number 6 aswell Lucky I have a spare head for the valves but going to need new guides Hopefully it will be all sorted in the next couple days But on another note, went and bought 105lts of united e85 Got it home and tested it Obviously tested on the high side but it settled at 94% ethanol! Should work very well with 35-40lb Some original photos have not been recovered yet.

...