Yeah think il just go some where in mandurah I'm not sure if I should try get over the pits with the big setup the only thing is the clearance issue between the manifold and chassi rail as it's 3mm not sure what an engineer would think about it any one had experiance with engineers ???

pretty sure it has to be 15mm clearence or somthing.

if you cut the rail dont draw attention to that area champ

did you cut rail?

you can get over the pits with 19inch rims mate, just apply for a permit while your there, mazza done that with his 19s. time for engineering man.... spend the $$$ and get it done. otherwise your gonna piss away money trying to get it over then putting it back, then next time you get stickered youll do it all over again or sell up. i hope you didnt cut the rail.... that would have to put you in the ****...

Yeah I trimmed the rail but it looks factory there's some parts of the rail towards the front of the rails that are factory so I copied them yeah I'm gona get engineered just with stock hot side

Have you got a stock hot side or you need to borrow stuff??

mannn that ****ing sucks. and just as you were ironing out the last couple of bumps too.. oh well, would be better to come back from all this with a permit or two, atleast stop them fingering you so bad next time.

Yeah steve I've got all the standard hot side kept it for a day like this went to a dpi approved work shop today and the guy seems fairly reasional so it's booked in for 3 weeks time that should give me enough time to get it stockish lol

what workshop was that davo? need to get mine checked out...

It's one out waroona so il let use know what the go is once I take it there

are you still going on the bbq cruise then?

Yeah mate il be there

just mandurah meet point or maybe a little earlier? i wont be going past mandurah if i come tbh.

Yeh mate mandurah meet point come the whole cruze il be on stockies on the rear Some original photos have not been recovered yet.

Good luck with it all mate... You taking it out to Pisconeri in Waroona?

Yeah mate he seems pretty fair and not a wanker like some pits in mandurah which pits did u take your car to ???

Took the vl to the diff and gearbox place today to see if my gearbox was the thing makin noise found out it's the diff as I've destroyed another pair of diff gear lol so the guy at the shops goin to speak to the redline rep and see if there's anything we can do to stop me wearing grooves in the gears these gears only lasted 3 months !! Lol

so y is it only making noise in first and 3rd then?

could it possibly be misaligned diff mounts or pinion angle ? surely thats not normal wear ay