Mine was a little tight also but still went in without to much problem, put some oil on it and it should go in. It should have a slot in the side to put tab into, mine did and you can see it in the pic above, its between the o ring and thread at the bottom of pic.

Quote: Originally Posted by VLCT Mine was a little tight also but still went in without to much problem, put some oil on it and it should go in. It should have a slot in the side to put tab into, mine did and you can see it in the pic above, its between the o ring and thread at the bottom of pic. Ohhh you mean the little 90degree metal bracket? Is that what is used to hold it in? I noticed that sitting half way up my cable. Will try some oil and see how we go...

off topic a little, i need the litle shaft that joins the speedo sender and the standard mx7 cable..i am using a mx7 sender with a r34 cog machined onto it. cheers dan

Quote: Ohhh you mean the little 90degree metal bracket? Is that what is used to hold it in? I noticed that sitting half way up my cable. Umm not sure what you mean by the 90* bracket, that seems like the bracket that screws to the floor to hold the cable. The one that holds the sender is a small square flat bit of metal which bolts to the side of the box next to the sender with a 10mm bolt and goes in the slot on the side of the sender to hold it in.

Yeah no the one I mentioned was to hold the cable... Just made up my own one to mount it on... Must have lost the proper one somewhere along the line...

Need some help guys. Is there a little metal piece that goes onto the end of the speedo cable that then slots into a seperate little inch long piece of metal that makes the cog spin in the speedo drive. Cos i think it had one but i lost it and need another one? Anyone help? Cheers YES i realise the threads ancient but some help would be greatly appreciated