do you sell the bullet nuts that holds the comp wheel on Some original photos have not been recovered yet.

Yes we can make them. They are machined from a block from aluminum. You need to give me the diameter of your comp wheel tip and thread size of shaft. They are $100 each. If you want to make few it becomes cheaper.

i want a cheap nut to bling up my turbo not an expensive nut witch could pay for an in line oil filter thanks anyway i thought you might of got them off garrett or something

try a local machinist he'd knock one of them up on the lathe in no time

Just we only use them in the ATR28G4 series as the comp wheel had to be machined to sit on a shorter shaft.To make one piece the time taken to get materials and setup the machine its going to be expansive. If you want around 20 pieces I can do it for $40 each.

ATR43 is now available. It is made to bolton Stock RB20/RB25's stock manifold, dump pipe, water in/out and oil drain. To install you need to slightly modify the inner water feeding pipe and 2x silicon hose for the round in and out lets. Also did a dyno run with a .63 ATR43G3 (same spec as ATR28G4) version on our 1.8L CA18det drifting car. Made 344rwkws (461RWHP). Some original photos have not been recovered yet.