lookin at a vr/s manual 304 ute to pull runing gear out of . It has tri y pacemakers.. wil they fit into my early commodore which has power steering? Cheer

Don't think so. You may be able to mod them

With some mods yes.

is it just the drivers side that needs more clearance or both sides? Are there any links on here showing the mods required? Cheers

give em a bash, mine were out of vs v8 manual. just had to massage them to fit, not much room!

Fit the vr vs k frame and steering racking and it will help you fit the pacemakers, should be no worries

so a vs v8 steering will fit into a vh when using the vs v8 kframe? ---------- Post added 13-09-14 at 20:59 ---------- or is it 2 wide? I have vk struts & lower control arms

99% sure they are ph 5000m tri ys

Vs rack and kframe will fit

thanks nasty 1 are vr/vs steering racks longer then vb/vn? Or is it just the tie rods that make up for the wider track?

Do not use the vs steering rack!! vn to vs v8 k-frames are all the same so you can use that and get a vn power steering rack and vl intermediate shaft and you will be sweet

Quote: Originally Posted by sle1982 [View Post] thanks nasty 1 are vr/vs steering racks longer then vb/vn? Or is it just the tie rods that make up for the wider track? The mounting points are not in the same position as vb vk etc... Vn-vs k frame works also does vl v8 rack.

thanks 84calais & nasty1. 100% understand the kframes are the same width VB - VS. but I heard somewhere the overall width on VR/VS was wider so i was thinking if the VR/VS rack was useable at all on a VB>VN conversion (not worrying about which intermediate shaft to use for second) maybe you could put the VB/VN tie rods onto the VR/VS rack?.....or is the rack itself to wide? hopefully it all works out with the ph5000m extractors.. looking at the pics on the pacemaker site. they appear to be the baby of the buch

Im running vn rack and pacies ph5700 headers.

forget the vs power steering rack altogether bud it has a square shaft where as the vl and vn have a round splined shaft where the intermediate shaft connects up unless you get it customised there is no intermediate shaft to suit vs rack into vb-vn.