Back to shop ↗
THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion
Holden Commodores gathered at Holdcom
Forum Home›CalaisTurbo archive
CalaisTurbo archive

[FS - NSW] Caged, mini tubbed, 8sec roller ($8500)

Started by grunter01 · 20 Jan 2013 · 6 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗

grunter01Archived member
For Sale? Or Wanted? FS Price/Amount 8500 Open to Swap? No State NSW Short Description for title? Caged, mini tubbed, 8sec roller Genuine Turbo Motor? A8? No Transmission? AUTO Currently Registered? No REGO/VIN Number? - Contact Info Other than this Forum? [phone removed] Description Hey guys i just bought this car a couple of weeks ago as i was gonna put my gear in it but am going a different way once again with it all. The car is ready to go just needs gearbox, engine and ecu so the car comes with pretty much everything else. I am sorry the car is dirty I should have cleaned it.... Any question please ask.... Full chromoly 6 point roll cage including under dash bar, taxi bar, side intrusions, Re-enforcment bars to rear seat, complete bar out into boot for parachute mount. DIEST Parachute with lever at shifter NOS bottle holder with lines Extinguisher Full clip on removable steering wheel with transbrake button Aluminium Sheet metal dash holding Stewart Warner 50mm Guages VOLTS Gauge WATER TEMP Gauge OIL PRESSURE Gauge BOOST Gauge TRANS TEMP Gauge FUEL PRESSURE Gauge Dash also holds Autometer Tacho shift light and low oil pressure light INNOVATE LM-1 METER, INNOVATE LMA-3 MULTI SENSOR INPUT MODULE Precision 3spd shifter 6AL MSD ignition MSD Blaster coil Transmission cooler with lines Toggle control switch panel Single piece JAZ pro stock drivers seat and Vinyl padded cover, 75mm race harness, Morroso Oil Accumalator with Braided lines to engine bay 45ltr Fuel cell, 2 x Bosch 044 fuel pumps, brackets, check valves, -8 braided lines EFI Fuel Regulator FE2 suspention Crysler shocks Boxed trailing arms 9" diff Disc brakes 35 spline axles 1/2" wheel studs Strange alloy carrier 4.11's full spool, WELD Racing wheels PRO STARS [Front] 24 x 4.5 x 15 with M/T Front runners [Rear] 26 x 11.5 x 15 with M/T ET STREETS. Car will fit a 12'' tyre under it Single 3.5" piece custom made Tailshaft with strange uni joints to suit C4 to 9" Brand new front bar Bonnet pins Shaven door locks The car has run a best of 9.06 @ 151mph kirk [phone removed] Some original photos have not been recovered yet.
0 likes
grunter01Archived member
BUMP.... Had plenty of calls and messages about the car so far. Call if interested or want to know anything about the car.
0 likes
grunter01Archived member
Bump ---------- Post added 24-01-13 at 21:35 ---------- May swap for nsw rego Calais turbo roller or complete car....
0 likes
grunter01Archived member
bump, still interested in a clean vl calais shell ---------- Post added 27-01-13 at 12:04 ---------- On ebay now with no reserve
0 likes
grunter01Archived member
yeah i know i am bad for changing my mind, gonna go another way but if no one wants this i will just racing it
0 likes
grunter01Archived member
bump
0 likes
grunter01Archived member
deposit taken
0 likes

This discussion is closed to new replies.

Who’s online

0 members and 4 guests active in the last 15 minutes

No signed-in members active right now. Guests are welcome to browse.

Visitors Today81

6,285 threads, 42,284 posts and 612 images saved from CT

18.4% of indexed threads saved