hey guys i am have al little bit of trouble i have brought a whole topend setup with a microtechlt10s and full wiring harness and finnaly put it in the car please note every thing is the same accept im runnig no cam and the car it came from had a tx2 the problem i am haveing i cant get any injector pulse to my injectors they have power and when i put a test light on them they squirt fuel i just cant seem to trigger from the microtech them nothing has been changes since the last car it was in and timieing is out because i can spray aero start down the plenum and it will start thanks guys by the way its an rb30 Some original photos have not been recovered yet.

did the injectors come with the Microtech? are they low or High impedance?

Yeah mate all the same stuff that came out of the other car they are 720cc denso

Still having this problem

a few things come to mind: the ecu either isn't dropping the injectors to earth (make sure injectors have a +12V rail to them. The start signal isn't being received by the ECU from the ignition switch and hence doesn't start injection. Is the fuel rail being primed by the ECU when 'igniton reds' or on? Is the microtech hooked up to the VL CAS signal or another CAS system?