Back to shop ↗
THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion
Holden Commodores gathered at Holdcom
Forum Home›CalaisTurbo archive
CalaisTurbo archive

[FS - QLD] Calais turbo manual ($17000)

Started by Tempest · 11 Aug 2012 · 3 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗

TempestArchived member
For Sale? Or Wanted? FS Price/Amount 13500 Open to Swap? No State QLD Short Description for title? Calais turbo manual Genuine Turbo Motor? A8? No Transmission? MANUAL Currently Registered? No REGO/VIN Number? - Contact Info Other than this Forum? [email removed] Description VL Calais Manual RB30T hey all, it has finally come selling my pride and joy. It's a series II 1987 Calais. Paint is in excellent condition, interior is very good for it's age, only showing a bit of wear on the driver's door card. So far is has gone 11.91@121mph on STREET tyres with the old MX7 it had in it. Since then is had made another 40hp and gained a lot of top end with the new inlet. Andy (OVL087) had the same setup as this except auto with some good fuel and went 10.8@124.8mph with slicks. Specs below. Engine WISECO forgies ARP rod bolts ARP head studs Modified oil pump and crank galleries TIGHE cams cam Heavier valve spring + retainers to suit Adjustable cam gear 6Boost low-mount manifold, HPC X-treme coated and wrapped TIAL 44mm gate Genuine GARRETT GT3082R (gt3040) roller bearing turbo RAJAB inlet manifold ARE 610x570x79 cooler with custom stainless piping Reco'd starter motor Fuel Rochester injectors Hi-volume volvo intank pump, + bosch 044 external PFI fuel rail, single feed + dual drain + speed flow to suit SX fuel regulator + speed flow to suit Computer MoTeC m4 with advanced tune/logging. MoTeC CDI ignition with mercury CDI coil QLD ignition leads Gearbox RB25DET 5spd, had 28,000km on the speedo of the car i personally pulled it out from. Had always run redline oil since i have had it Full face 3400lbs clutch Rebuilt turbo 2pc tailshaft with heavy unis Diff Standard BW housing Detroit locker New billet axels (less than 6000kms on them) 3.71 gears Solid pinion spacer Upper control arm mount rewelded on diff and on body Whole diff has had a rebuild less than 12,000km ago Brakes VT twin piston fronts, x-drilled and slotted with EBC green stuff pads standard rears Stereo Kicker 300x(?) amp Kenwood 6x9's, 4" splits at front (nothing cut) Pioneer head-deck MTX 12" sub 3" exhaust turbo back Autometer Ultra-light boost, water temp, oil temp and oil pressure Battery in boot Manual steering rack Proper fuse rail Pedders sport ryder suspension New bushes throughout Turbosmart v-port BOV AVC-R control Valve run by the motec motec shift light Mod Plate for everything that can be done I have tried to do everything in this car the RIGHT way, not the CHEAP way. Everything in this car has been replaced over the last few years, from brakes to bushes. Price is neg depending if you want the wheels. Car is currently unregistered and will be sold unregistered. getting a RWC should be easy as the car is complied. Please Pm for further details. Some original photos have not been recovered yet.
0 likes
TempestArchived member
price drop.
0 likes
4Man_89Archived member
Hi, im interested have you got a phone no.? or mine is [phone removed]
0 likes
TempestArchived member
Sold
0 likes

This discussion is closed to new replies.

Who’s online

0 members and 0 guests active in the last 15 minutes

No signed-in members active right now. Guests are welcome to browse.

Visitors Today1

12,749 threads, 101,510 posts and 1,281 images saved from CT

37.2% of indexed threads saved