Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗
* comp cams pushrods $100
* lunati voodoo 1.7 ratio fully adjustable rockers. Cost $700 sell $450
* jp double timing chain and mellings high vol oil pump to suit (oil pump casting to suit double chain so no spacers !) $300
* siemens 42lb injectors, 1.5l surge tank, bosch 044 fuel pump, turbosmart fpr800 fuel reg.... Cost me over $1000 chasing $700
* ss inductions 100mm intake pipe with pod filter $150
* patriot gold valve spring kit.. Comes with everything not just springs $250
***** everything above has done 2000kms max *****
located in melb south east... Can post anything !
0 likes
Ey bud I'll take the coil packs can u msg me [phone removed] thanks
0 likes
What comes with the starter relocation kit ?
0 likes
Everything.... It's a kit.
Starter plate. Dowel pin. Bolts. Starter motor etc
It's for an auto so the only thing u need if u have manual is the spacer behind slave which is $20 from CAE
0 likes
email sent mate, inbox is full
0 likes
10-04-12, 11:57 GMT+10#10 can i have pics of exhaust to [phone removed]
0 likes
10-04-12, 22:47 GMT+10#11 Also interested in exhaust, tailshaft if it suits ute, stater relocation and wiring loom at this stage. is trans sold?
pics to [email removed] or [phone removed]
0 likes
11-04-12, 00:43 GMT+10#12 Some original photos have not been recovered yet.
0 likes
11-04-12, 08:57 GMT+10#13 hey mate dont want to burst your bubble but the patriot springs are a lot more expensive that what you get them brand new for.
0 likes
11-04-12, 09:16 GMT+10#14 **** looks like i got ripped..... dont worry bout springs ill keep them
0 likes
11-04-12, 21:04 GMT+10#15 are the rockers ratio the same as standard ratio? will they make any difference compared to standard rockers??
0 likes
12-04-12, 12:53 GMT+10#16 they are standard ratio but fully adjustable so u can adjust all your preloads etc..
---------- Post added 12-04-12 at 12:58 ----------
edited first post not much stuff left !
0 likes
12-04-12, 15:45 GMT+10#17 what size are the pushrods??? should be etched into the side of them
0 likes
This discussion is closed to new replies.