Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗
iv just finished the turbo setup on the calais and now theres an oil leak coming from what seems to be the brass washer on the oil line , can you reuse the brass washers or should they be brand new each time. besides that the car runs fine just need to get this sorted. also when i look at the line it seems like the washer isnt in the center of the feed may this be the problem
0 likes
I prefer to use a new one.
0 likes
does any 1 know the size of the washers so i can get afew new ones and chuck em on. as the ones on the line now seem to be 2 diff sizes one is smaller then the other
0 likes
permaseal do a kit and check you havnt cross threaded the banjo cos thatll make it leak too.
0 likes
yep the permaseal come with the oil feed and drain gasket. t3 gasket. dump and brass washers for banjo's
just take the banjo bolt out and bring it to autobarn or pirtek
0 likes
mad nah hasnt been threaded was a stuff washer (1 was the wrong size and it was dripping (pulled it out again and going to get a washer when shops are open so most likey tomorrow
---------- Post added 17-03-12 at 18:19 ----------
have to wait for tomorrow then ill go check out autobahn ect other wise enzo on monday
0 likes
Just need a copper washer, should be able to get it at a plumbing store or bunnings etc
0 likes
