Anyone got any tips for being able to run ultra lows and 20s in the rear with out it trying to rip the rear bar off

what size tyre i had same problem with my 19's basicly i took the end cap of the trimming off which cleared it a little. i then got my guards rolled but its all about the tyre size you may need a 225 if you have a 235 things like that

What width rims and you running? what size tyres? What offset? Adjustable panhard rod?

There only 8.5 man runnin 225/30/20 its millimetres on the left scrubs the bar on right side

Guards are rolled

have you got a adjustable panhard rod mine is like this and all i need to do is adjust my panhard rod to the passenger side a little. no point lowering a vl without a adjustable panhard rod its a recipe for disaster

You need to trim the bumper return.

8.5's are fairly wide in terms of low low low on 20s. mine are only 8's. Adjustable panhard rod is a must hands down. At rest, how much room is there between rim to guard on each side?

Trim the bumper, roll the guard, and trim the end cap (I cut the mounting screw part off and sikaflexed it to the trim)

thanks boys .trimmed the bar put a pan hard rod in all good Some original photos have not been recovered yet.