Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗
Hey guys selling parts off the engine in my car due to upgrading, All parts are still in good condition. This setup has ran 10.86 @ 123mph. Setup has 12:1 comp ratio, and was tuned on 98 octane. Parts for sale are below.
COME Racing 355 stroker crank
COME Racing Forged pistons
COME Racing "I" beam rods
Yella Terra 1:65 ratio roller rockers
Push Rods
Solid lifters to suit solid camshaft
VN Heads flowed at 256.6 cfm, (just under 550hp) with 2.020 inlet, and 1.6" exhaust. dual valve springs, moly retainers.
Heads come with complete flow charts, and cfm chart.
Heads are painted gloss black.
This setup simply needs your own block machined to suit, a solid cam of your choice (this setup worked best with the 288 cam) and rings and bearing kit.
This setup made 310rwkw with a 3 speed transmission.
Engine was reving over 7,000rpm with no problems at all.
The whole lot complete $4,000.
Also selling Di Filippo exctractors, which are HPC coated (polished finish)
$500
PM me or contact me on [phone removed], located in northern suburbs melbourne.
(can post anywere in australia)
Some original photos have not been recovered yet.
0 likes
how much for just bare heads with valves only
0 likes
Hey mate what car do the difillipo extractors suit. Thanks
0 likes
yep correct, there in the VN, so id say VN-VS.
kevspec: Id only separate parts if other people are intrested in the remaining parts.
0 likes
will the pistons fit in my ford?
0 likes
Quote:
Originally Posted by freEze_dK
[View Post]
will the pistons fit in my ford?
No but lm sure Steff could jam em somewhere else :)
0 likes
What machining will a block need to fit the slugs? Using a VS 355 block?
0 likes
08-10-11, 20:10 GMT+10#10 Quote:
Originally Posted by slideways
[View Post]
What machining will a block need to fit the slugs? Using a VS 355 block?
What do u mean by slugs??
0 likes
08-10-11, 22:11 GMT+10#12 Mate depending on what over size they are u won't need any machining other than a re bore
0 likes
08-10-11, 22:24 GMT+10#13 oohh lol... sorry didnt know they called em that, i just know em as pistons. and yeah what boosted wagon said above... a basic re-bore to get em all to fit.
0 likes
11-10-11, 15:17 GMT+10#14 time to up the anti mr stowln ;)
0 likes
11-10-11, 16:38 GMT+10#15 Quote:
Originally Posted by VL INJECT
[View Post]
time to up the anti mr stowln ;)
oohh... it will be... ;)
0 likes
11-10-11, 18:47 GMT+10#16 if you advertised this in a 1 months time stef i woulda bought it, dont have the cash atm but its exactly what i need :(
0 likes
This discussion is closed to new replies.
