hey guys so got a jvc amp here hooked it all up was workin fine for first ten mins then wqent into protect mode hasnt been out since wiruing and everything sweet took it to audio shop pulled it apart tested it hooked it up again same thing.. nothing wrong with it from what they could find any ideas?

Could be a number of things. Wrong polarity, wrong ohm, wrong resistance or your speakers could be stuffed. What amp are you running with what speakers.

hey thanks man but i dont know what any of that stuff is um two 6x9 jvc 450 watts and the amp is a mosfet 600watt i think?

JBL 6x9 450 watts 4 Ohms 150W RMS I think the mosfet 600watt amp is 2 ohm stable. Which should be OK I think. Do you have any larger speaker or subs you could connect instead to see if that would fix the problem. Also just curious. What gauge power wire are you running/using? & do you have a multimeter? Some original photos have not been recovered yet.

nah none of any of that stuff mate and four gauge

i had the same problem when i hooked my first sub nd amp up years ago ended up not having a good enough earth sub would pump down low but turn the stezza up and it would cut out i just found a new ground and sweet as