Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts. View original archive ↗
So if you have 2 x 12inch subs that are rated at 300w rms each
What sort of amp should you use to power them?
I was originally going to use an alpine 500w rms Monoblock that I bought off a guy on this forum, but since saying i'll have it he has dissapeared into the underworld.
So I need an amp to run my subs what can you reccomend?
How much power does my amp need to have and whats the difference if I get a higher powered one?
The jaycar precision amp is only 300 bucks = @ 1 ohm mono 14.4V: 1000WRMS
Compared to say an alpine monoblock that is 500wrms and $500
Thanks for your help
0 likes
Haha i told the same dude i would buy them and he ran away aswell.
I would be looking at an alpine one or a kicker one, both are good quality and kicker even if rated at 400wrms are individually tested and always put out more power
0 likes
Quote:
Originally Posted by WeLLsY
[View Post]
So if you have 2 x 12inch subs that are rated at 300w rms each
What type of subs are they. (specs ohm max watts power)
0 likes
Subs here - http://mobile.jlaudio.com/products_e...13&prod_id=593 (http://mobile.jlaudio.com/products_enclosures.php?menu=13&prod_id=593)
0 likes
2 ohm speaker on 4 ohm amp, No good I reckon, will be to much load on the amp. It will most likely go into protection mode & shut down.
Some original photos have not been recovered yet.
0 likes
Take them out and wire them is series to get 8ohms.
Wont be as loud but wont cook your amp.
0 likes
MTX Audio do some mad gear. Look up the gothic style amps hell good. If ur after something cheap, get a 4 channel and bridge each sub across two channels. descent one will cost ya bout $200 and put out more than enough power to run ur subs.
I had a similar setup in my car and was running 132.8db's with a descent tune
0 likes
What about an Alpine MRP-M1000 monoblock amp....
So it's 1000w rms @ 2ohms
Amp is here - http://cgi.ebay.com.au/vl-turbo-wago...item3f08227aeb (http://cgi.ebay.com.au/vl-turbo-wagon-/270719417067?pt=AU_Cars&hash=item3f08227aeb)
0 likes
Quote:
Originally Posted by WeLLsY
[View Post]
What about an Alpine MRP-M1000 monoblock amp....
So it's 1000w rms @ 2ohms
Amp is here - http://cgi.ebay.com.au/vl-turbo-wago...item3f08227aeb (http://cgi.ebay.com.au/vl-turbo-wagon-/270719417067?pt=AU_Cars&hash=item3f08227aeb)
If the amp is rated to do 2 ohms then thats fine, it will handle it.
That puts 500 watts into each sub which should be plenty.
0 likes