started stripping my vlt on the weekend still have everything but the coldside mr turbo t66 800hp billet turbo on 6boost manifold with 44mm tial gate and 4inch dump all lines and intake. turbo done 200kms since rebuild due to manufacturing fault sold forged rb30 engine, eagle rods,arias pistons, n1 oil pump, high energy race sump, ported head with oversize stainless valves, head studs, tighe cam, 3 angle valve grind, cometic gasket, bottom end prob done 2500 kms, head done 500kms, $6000 r33 5spd gear box with hks twin plate clutch set up for pull type clutch and built tailshaft by hardie spicer $2200 motec m4 ecu plugs into standard loom 4 months old built into standard ecu case. installed by rajab has shift light and logging enabled $2000 microtech lt10s with dash unit and laptop dongle and full loom with crane hi6 ignition sold will post more items when i get around to it pm me on here or txt me on [phone removed]

bump

microtech is sold still heaps left

bump

bump

bump

PM sent

how much for box without clutch

box and clutch go together cause of the push to pull conversion

hey mate could you pm me the details of the block ie who built it and whats in it..also a price if you would seperate block from head. thanks ben

the engine was built by bob hawkins chiptorque. i wont seperate the head from it and as for whats in it its in the the first post turbo and manifold are now sold