05-11-10, 19:21 GMT+10#1
all parts have done about 1000 kms. fresh as. basically just got it running properly on 34 psi making 805fwhp on pump plus methanol mix and had some drunk guy pull out on me and wrote the front end off. Have other priorities at the mo and couldnt be ****ed doing all the shell prep to get it back on the road again so im selling all the running gear.
ENGINE
Fully prepped block
CP forged pistons with rings and locks
Howard I-beam billet conrods with ARP 2000 rod bolts
Kings bearings
ARP mains stud kit
Custom 7ltr sump
Peterson external oil pump
1000hp ATI harmonic balancer
GTR N1 water pump
All speedflow fittings and braided lines
HEAD
New Head
bigger valves
mild porting
everything reconditioned
multi layer steel head gasket
half inch head stud kit (stop head lifting under big boost)
1000cc injectors
Tighe cam
will only sell as long motor, not taking the head off - $6700
HOT SIDE SOLD
1000hp MR TURBO custom T76 billet turbo - polished front, black extreme coated rear - similar specs to T51R ($2800 turbo)
6BOOST custom high mount exhaust manifold coated with black extreme heat coating
Tial 44mm external wastegate positioned off turbo exhaust housing for superior boost control
All braided lines and speedflow fittings
COLD SIDE $1200
Specialised Power Porting custom billet plenum and inlet runners ($2000 plenum)
80mm billet throttle body
FUEL SYSTEM SOLD
Custom billet fuel rail
RCI 75 ltr fuel cell
Carter lift pump
surge tank
Two bosch 044 external fuel pumps
All braided fuel lines with speedflow fittings
ECU and IGNITION SOLD
Autronic SMC
Autronic CDI 500R ignition booster
TRANSMISSION have receipts for $11,300 SOLD
2000hp rated 2 speed powerglide built by MV Autos
REID Aircraft Alloy Racing Case and Tail Housing with Roller Bearing
Billet straight cut planetary gear set
Vasco Shafts
Transbrake
TCE stall converter
One piece tailshaft
B&M pro ratchet shifter
PWR trans cooler with thermo fan
All speedflow fittings and braided lines
EXHAUST SOLD
3.5 inch stainless from dump
professionally welded bends
dump pipe, long mid section pipe, muffler/resinator (3 piece system)
DIFF SOLD
Kazz mechanical LSD ($2200 diff center)
perfect condition
just the diff center but if u want the whole thing with 28 spline axels and vl turbo rear brakes i'll throw that in with it.
spent 50k on the above parts and labour (got looked after on the labour side too). no intercooler, radiator, or coil - destroyed in the accident. please dont enquire if you dont have the money. ive already been ****ed around royally by someone who was going to buy, now has cash flow problems and wants deposit back. i wanna sell everything as a package or at least have buyers for everything before i sell. i spared no expense building this driveline. it has the best of everything. is good for plenty more power and even more with a bigger turbo. its practically brand new. ive never thrashed it. i like to take care of my stuff and besides never had it on the road long enough to thrash. been on the transbrake three times in total and did baby burnouts. Im not desperate to sell, infact would love an excuse to keep it, so i wont accept any unreasonable offers.
---------- Post added 05-11-10 at 19:36 ----------
Rob [phone removed]
0 likes