Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.
hey guys im doing a dodgy turbo conversion on a n/a just so i can have a bit of fun while i save up more cash for a full rebuild i was just wondering were would be the best and easiest place to tap the water and oil lines in a series 1 86 block and i was wondering how easy is it to fit a tranny cooler on the trimatic auto could u plz give me some steps do this plz cheers in advance guys
0 likes
mate i got the oil/water lines for a s1 here.
oil feed: oil pressure sender
oil drain: get the oil drain fiting and put it in the sump
water feed: drill a hole on the thermostat housing and put the fitting in there
water drain: get the fiting and send it back into the heater hose
anymore help just let me know
0 likes
Quote:
Originally Posted by vl_turbo6
[View Post]
mate i got the oil/water lines for a s1 here.
oil feed: oil pressure sender
oil drain: get the oil drain fiting and put it in the sump
water feed: drill a hole on the thermostat housing and put the fitting in there
water drain: get the fiting and send it back into the heater hose
anymore help just let me know
thanx mate i appreciate the help
0 likes
