THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion

Forum Home›Technical help

Technical help

panhard rod help

Started by vl__feva vbmenu_register("postmenu_2279502", true); · 9 Sept 2009 · 3 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.

vl__feva vbmenu_register("postmenu_2279502", true);Archived member

09-09-09, 15:44 GMT+10#1

hey i just bought a new adjustable panhard rod and just wondering if there is anything i should know about installing it, thanx

0 likes

Mattuz vbmenu_register("postmenu_2279553", true);Archived member

09-09-09, 16:40 GMT+10#2

all you really need to know is to make sure your car is supported by axle stands on the jacking points. then when you take the old one off make sure you put some rubber grease on the bushing before you put the new one in. then its just a matter of guess and check until its sitting even

0 likes

vl__feva vbmenu_register("postmenu_2279636", true);Archived member

09-09-09, 18:04 GMT+10#3

thanx

0 likes

nicksvl vbmenu_register("postmenu_2279722", true);Archived member

09-09-09, 19:18 GMT+10#4

if the new rod already has the bushes pushed into their places it will only go on one way, so just throw it on with a bit of rubber grease. then when its back on the ground, adjust it so the gap between the guard and the tire is the same

0 likes

Sign in or create an account to reply. New members are welcome—no purchase or old CT account needed.

panhard rod help

Who’s online