What is the fastest standard cast piston vl out there??

I believe Mark- Bigpsi would be close, 9.7? from memory?? 6BOOST

i think that r31 has beaten that now http://www.calaisturbo.com.au/showth...ghlight=SENSBL (http://www.calaisturbo.com.au/showthread.php?t=115563&highlight=SENSBL) i know 100% thats a standard motor. no o-rings or nothing. p.s i know its not a VL, but same **** dif bucket if u ask me... i think both of them are nuts! lol

did rajab run a low time in the red car they had nizpro one? on cast bottom end

not sure, i dont know if that r31 is the quickest, but it is quicker than BIGPSI on standard cast pistons, not sure if theres any others out there ppl post them up!! would be interesting to see how many ppl trust there bottom ends that much! lol

Quote: Originally Posted by ANK did rajab run a low time in the red car they had nizpro one? on cast bottom end wasnt that bottom end unopen ank?

i think it was a hi comp set up ill get the link off the nizpro site

Rajabs red car went 9.8 on casties i think..long time ago though, alot has changed. woudn't be hard to beat that now, if you were going for that as a specific goal, i woudn't be suprised if you could run low 9's at high 140+ mph Time bomb though, question of when not if cheers darren

http://www.nizpro.com.au/no_laughing_matter_main.html

unopened is even better!! that r31 has had a full reco, anyone know of any unopened VLT's that have run a few passes and lasted a while?

I believe JPC ran 9.2 with standard pistons and conrods in Vas Stoganovski' car in the early days, Mark told me the car made 470rwkw like that but broke a conrod almost every meeting and on the dyno but never hurt the cast pistons, this was before they went to forgies and alloy conrods Cheers Tobie

ill win soon :P haha

Quote: Originally Posted by botie I believe JPC ran 9.2 with standard pistons and conrods in Vas Stoganovski' car in the early days, Mark told me the car made 470rwkw like that but broke a conrod almost every meeting and on the dyno but never hurt the cast pistons, this was before they went to forgies and alloy conrods Cheers Tobie what aloy rods where they running mate?

good luck bouras lol

haha bouras i remember when u thought the fastest was a 11sec pass about a month back lol and u were telling me u wanted the record until i told u the bad news :P

Quote: Originally Posted by RBPower good luck bouras lol hahaha thnx lol.. ill be happy with a 11 and super dupper happy with a 10 Some original photos have not been recovered yet.

Quote: Originally Posted by ANK what aloy rods where they running mate? No idea ANK but i think it still has alloy rods last time i spoke to them about it Cheers Tobie

interesting......thanks for that mate

didnt that rajab racecar before it was fully tubbed with a junk motor and a much smaller turbo run 9.1 at 151 on a stock motor.

Quote: Originally Posted by [SLY.747] would be interesting to see how many ppl trust there bottom ends that much! lol as u see the fast times are workshop cars, which could be re built at the drop of a hat, most ppl who drive there vls regularly'ish wouldnt wanna have such an unreliable bottom end lol.. Some original photos have not been recovered yet.