Can someone confirm 100% how much to torque ARP HEAD STUDS in ft-lb? (preferably from an instruction sheet) Also do u need to use moly lube?

i used moly lube from repco as nobody else had any(not arp).. we tightened them to 60ft even though below says slighty different.. make sure u go through the same procedure that it says in holden book.. tighten to a certian amout then tighten firmer again.. then loosenn all the way then copy-tighten to a certian amout then tighten to the final setting.. make sure u do it in the right order of bolt numbers... .. Some original photos have not been recovered yet.

thanx champ. thats perfect. how come u didnt use their specs and settled for 60lb Im actually running 1/2" head studs. Can I get torque setting for 1/2" head studs

no sorry i just rechecked the torque wrench and sure enough holdens setting of 88nm is just about 63-64ft..so only a couple off..

anyone

Just use the standard Holden recommendations, if you're using moly lube... if your not using lube, then add another 5-10 ft/lbs to the final torque setting but leave the rest the same.