hi just thought id post up here at least it will get looked at being in the v8 section.
parts as follows,
- vr block all machining done, 30tho over, block clearanced for stroker crank
bottom end grout filled to bottom of welsh plugs
- scat 5.7" steel rods
- custom steel stroker crank 366ci 2 inch journal
- arp main stud kit
- custom steel 4 bolt main caps
- rollmaster double row timing chain
- vn heads flowed to 560hp heads complete just been serviced,
stainless valves,( 1.67- inch inlet/ 2.04 inch exhaust. ) triplesprings,
crane 1.65 stud mounted roller rockers, HDT push rod guides
$6000 my phone number is [phone removed] call after 5pm
or just pm me.
or will swap for something of interest
the pics arnt the best dont know if these will help but i will put
them up anyway
Some original photos have not been recovered yet.
Quote:
Originally Posted by Epitaph
looks like it;s just a bottom end with a set of heads.. no cam, manifold, etc.
yes thats correct,
Quote:
Originally Posted by EAT-30T
just put it together you dopey prick.......
yeah ok i will just pull the money out of my ass.....
the reason im selling this is cause im over it.....
Guys I can tell you this motor is the goods
It also has 'steel' 4 bolt mains not cast holden ones... Is fully machined and ready to assemble the heads are setup for a roller cam.
All you'll need to finish is
Pistons (subject to your choice of comp)
Cam, lifters & pushrods (subject to your choice of stick)
And your accesories of course whichever way you choose to go. EFI Carb???
Quote:
Originally Posted by EAT-30T
Guys I can tell you this motor is the goods
It also has 'steel' 4 bolt mains not cast holden ones... Is fully machined and ready to assemble the heads are setup for a roller cam.
All you'll need to finish is
Pistons (subject to your choice of comp)
Cam, lifters & pushrods (subject to your choice of stick)
And your accesories of course whichever way you choose to go. EFI Carb???
thanks man i forgot to put up the 4 bolt main caps
