Wtf??????

yes = wtf did i do

i vote make more threads on this maybe people will notice you

lol mate wat's the five thread's for?? and an apology for the wtf

dont know what I did must off duplicated something

Quote: Originally Posted by local dont know what I did must off duplicated something What I meant to say is I'm currently wiring up my microtech and dont know what colour wires to splice into for the tps and cas The factory loom wires CAS- Black,Orange/Black, White, Yellow Microtech loom wires CAS- black, red, green, white The factory loom wires for the tps- Green,Blue/White,Blue Microtech loom wires tps- blue,grey, brown Any help would be good Already tried searching for help

blame gavin

The cas, tps wiring all sorted now thanks to DeVL. Any help/explaining on same problem msg me.

Quote: Originally Posted by local The cas, tps wiring all sorted now thanks to DeVL. Any help/explaining on same problem msg me. Hey Guys, Any advice on the TPS would be greatly appreciated. My factory loom had (from top to bottom on the TPS) White/Black, Green/Red, Light Green/Something..... the microtech is Blue (+5v),Grey(sig),Brown(gnd). Tracing the loom out im gathering its : Blue - > White/Blk Grey- > Green/Red Brown - > Light Green / Unknown I not getting any TPS signal through to my microtech (just sits at 99% with or without tps plugged in). I put a multimeter accross the top 2 terminals on the TPS and i get no reading at all except for the WOT position i get continuity. I get no other continuity accross any other combination of pins in any other positions. My question is.. is my TPS just a WOT switch, or is it Fkd? The Engine is from a VL, but it is in an R31 Skyline. The TPS is a Nissan part, black with '293024' written on the plug. On the underside it has JECS Made in Japan with ' A22-626 911' on it. its has a single 3 pin plug from the side. Any advice would be greatly appreciated - Russ Some original photos have not been recovered yet.

Yes the VL TPS is just a switch. It can detect idle and WOT....thats it. The microtech obviously needs to see a variable resistor type TPS. Try sourcing something from the wreckers. I can tell you an R33 RB25 has the type of TPS you are after.....not sure what else is compatible.