Ok anyone here done the swap of the autronic trigger disc into the CAS. I know you tap the pin out and press off the bearing but how do you get the rest of it apart?

hey mate you take the cover of tap the pin out remove the bearing then there is 2 screws that fasten the plate that holds the disk in, remove it, then remove the light emitting diode unit (2 screws) then pull the disk off. now ur at the hard part, this isnt easy to install and u should get the software so you can find the certain degree of engine rotation and trigger disk degree, go to the autronic website www.autronic.com (http://www.autronic.com) and download the software for the trigger installation and the instructions, i done this myself and it was a headache it took me a few hours just cuz i was doubting myself and i kept double checking need anymore help then pm me good luck mate cheers brad