THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion

Forum Home›Technical help

Technical help

Oil pressure sender 5.0i

Started by Boyracer vbmenu_register("postmenu_1071219", true); · 27 July 2006 · 4 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.

Boyracer vbmenu_register("postmenu_1071219", true);Archived member

27-07-06, 18:09 GMT+10#1

I have had my VR 5.0 conversion for a while bit never had the oil pressure guage working properly in the VL,does anybody know the best way to get the guage going,thanks?

0 likes

NVIOUS vbmenu_register("postmenu_1071232", true);Archived member

27-07-06, 18:13 GMT+10#2

The sender is ontop of the oil pump housing (where your oil filter is). You could always just run an aftermarket oil pressure gauge - you just replace the old sender with the one in the kit.

0 likes

Sinister vbmenu_register("postmenu_1074214", true);Archived member

30-07-06, 12:35 GMT+10#3

yeah the time ***in around with the factory one id honestly just connect up an aftermarket one... make sure its connected up snug and tight, u dont want oil shooting in your cabin Some original photos have not been recovered yet.

0 likes

hot308vb vbmenu_register("postmenu_1076328", true);Archived member

31-07-06, 17:47 GMT+10#4

ive been down this road before, you can buy a 't' piece that suits the factory oil pressure sender thread type so you can run the std oil sender as well as the oil switch for the computer in the same fitting. you just connect it to the factory wire (blue i think) that runs to the dash, this operates in the same mannor as normal. cheers

0 likes

Boyracer vbmenu_register("postmenu_1077888", true);Archived member

01-08-06, 18:04 GMT+10#5

Bewdy thanks mate.

0 likes

Sign in or create an account to reply. New members are welcome—no purchase or old CT account needed.

Oil pressure sender 5.0i

Who’s online