Back to shop ↗
THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion
Holden Commodores gathered at Holdcom
Forum Home›Technical help
Technical help

removing top half plen

Started by [T]Matty vbmenu_register("postmenu_821153", true); · 15 Jan 2006 · 7 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.

Hello, There is 7 bolts all up. 4 top 3 bottom, The 3 on the bottom are differant lengths.. one is shorter, Thats the middle one, dont muck it up. all 4 on the top are all the same so its ok there. There all 12MM also. the 3 on the inside closet to the head are the ones under, The outer ones closest to me are on top. Here, You can see were thay all are
Photo 1 shared by [T]Matty
vbmenu_register("postmenu_821153", true);
0 likes
Note: It may be hard to get off still... get something soft like a rubber mallet and give it a bop, it should just pop off.. the VLT plens are a little differant.. But the bolts are like within 10mm of the NA ones so you get the area they are..
0 likes
Are they OHS approved steel capped boots?
0 likes
nah mate theyre hobbit spec
0 likes
give u a bop to the head in a minute Some original photos have not been recovered yet.
0 likes
Narr i had a blow out in one of my steel cap pluggers.. I was devo..
0 likes
Bop is a cooler word.. Its so non lebo and ****..
0 likes
are u being racist ? na good quick write-up... .should help a few people Some original photos have not been recovered yet.
0 likes
Sign in or create an account to reply. New members are welcome—no purchase or old CT account needed.

Who’s online

0 members and 1 guest active in the last 15 minutes

No signed-in members active right now. Guests are welcome to browse.

Visitors Today9

33,602 threads, 484,230 posts and 24,897 images saved from CalaisTurbo.
As at . Recovery is continuing.