how the **** do ya get the bottom door pin out??thanks.

top 1's go down and bottom 1's go up

they wont come out if you tap them down... it hits the door shell

i know that, i got the top one out, im hitting the bottom pin upwards but the **** wont move

thats why u cut it off as it comes out :P and replace the pins P.S soak the SHIT out of it with WD40 or similar Some original photos have not been recovered yet.

id love to cut the door pin off if i could get it to move.

hit harder then

These can be a real Pain ,,,, if you are using a Pin removal tool and WD40 or something similar and it won't budge , then it could be a pin that has got a kink or worn to one side , then it will get stuck as it will hit part of the hinge when you are trying to drive it out , you may need to use heat on it and see if you can look through the pin to see if it is bent , I've got the same problem with a VL SW , got the top and bottom part of the pin out of the body hinge, but the centre of the Pin is still stuck in the door hinge , will soak this and drive it out with a long punch from the top , but then the bottom pin would only move part of the way before getting stuck as well , the pin was kinked ...I may need to break the pin to remove this one , will let you know how I got on , best advise is to remove the Pins before you really need to , and keep then lubed .

This is a hinge Pin remover , there is a solid one for removing solid pins (Fords etc) but this one is for hollow pins , three different sizes , you unscrew and insert the correct size shaft through the pin and reconnect it once through , remove the bottom pin from the top by having the larger end to the top (this is where the tool slides onto) then using a small hammer hit the tool up , you will need to use lube WD40 etc to help the process , if you are lucky the pin will come out quite easily , remember to support the door as you are doing this . Some original photos have not been recovered yet.

And they work a treat, ive removed many doors with mine, and ive bent it from hitting it, but its really good

yeh dont worry i got the doors off, with the first door i broke 2 pins that came with th door pin remover,so i hit out the other pins and cut little bits of and kept hiting them as jet 6 said before

Great job isn't it! Done it on one of my vls, tops are easy, bottom takes more time and patience which I dont have! Orange_VL, Aren't you a spray painter, if so surely ppl at your work could have done it for you with their eyes closed?

yes i am but the car is in my shed at my house,yes my house pulled down to the shell and work is half an hour away, i dont see the point of towing it all the way out there and back again.