hey guys i just did a manual conversion and rewired the two purple wires in the engine bay. i try to start it but nothing happens. all i hear is the fuel line. no sounds from the starter either. any help greatly appreciated. thanx

Steve did you use a 5 speed VLT stater motor?

hmmm i think its just a n/a 5 speed starter will that make a difference?

Yeah man it would Some original photos have not been recovered yet.

so could that be why it isnt even kicking over?

Yeah sure is

you will still hear the starter spin

ok thanx man so how can i fix it?

nah the starter doesnt spin. only priming no other response

i turn the key as far as it goes and when i reach the end the accessories turn off. no response except priming. any ideas? thanx

It must be something to do with the neutral start switch, are you sure you have wired it properly?

hey guys, thanks for your help so far, i think i wired it correctly. i have read a few threads on this and i did what they say to do. i removed a relay from near the battery and then joined the two purple wires near the relays but i am getting nothing but electrics and fuel. will check the spark and that fuel is actually getting to the rail. have i done the re wiring corectly? Quote: Steve did you use a 5 speed VLT stater motor? hey rubin, why do i reed a vlt starter?

by the way i did a temporary n/a conversion as i am waiting to get an r33 box so i have a 9.5 clutch so am using an n/a manual starter.

Steve you can only use 5 speed starter motor on a manual gearbox...If you can grab a VLT Starter motor of someone give it a go Steve you sure the starter motor is on right? Some original photos have not been recovered yet.

thanks for your help guys but i got her going. it was wired up wrong thanks, Steve Some original photos have not been recovered yet.

LOL Good to hear steve Some original photos have not been recovered yet.