Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.
My tail shaft is in need of a rebuild. The uni-joints have lots of play in them and the centre bearing is stuffed as well.
So, I was wondering if all of you folk out there just replace std (turbo spec mind you) with standard parts, or if there are stronger alternates. I run up to 15 psi boost (but not all the time) thru it too.
Ps. Can any of you kind Novocastrians (Newcastle folks) recommend anyone in the area for this kind of work.
Thanks
0 likes
Oh and how much did it cost ya's?
0 likes
expect to pay around $450 for rebuilt tailshaft, incl CV joint. to my knowledge there are no cost effective strength modifications and a new one should hold up well for a long time
0 likes
cost me bout $250 for full rebuild and balance...mates rates The centre CV is about $120 on its own.
Some original photos have not been recovered yet.
0 likes
I just got my tailshaft rebuilt for $300. inc two unis,Center bearing, and CV.
This was between one and two hundred cheaper than most other places i called.
This was with quality parts (jap and italy)- the unis on it (previous to rebuild)were made in Taiwan.
0 likes
I'm gettign mine done properly and cheap-ish (trade and a wristy). $390
New MX7 Yoke
New VLT CV
New H/D USA (brand) unis
assmebly and balance
You won't find a better price than that with that gear in it.
0 likes
