THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion

Forum Home›Technical help

Technical help

calaisturbo.com.au - Manual Conversion-wobble

Started by sigmund · 2 Nov 2004 · 2 replies

Preserved from CalaisTurbo. Original authors and dates are shown; archived members are not current Holdcom accounts.

sigmundArchived member

02-11-04, 17:33 GMT+10#1

Hey, After completing a 5spd conversion on my VLT i have a slight wobble at idle. It go's away if i rev to about 1500rpm upwards. This is when it's in gear/clutch in,out of gear clutch in or out. This makes me think that it would be a flywheel balancing problem??? Or could it be the input shaft/bearings worn? I'm fairly sure its not a motor problem as it didn't do it with the auto. Thanks for your help.

0 likes

sigmundArchived member

04-11-04, 13:40 GMT+10#2

Bump. Anyone have a wobble at idle? It's not missing at all...

0 likes

neubyArchived member

10-11-04, 19:21 GMT+10#3

I'm not sure if this is the problem but make sure you've still got the idle air solenoid hooked up. I manage to bump mine off when I did my conversion and I couldn't figure out what was wrong for the live of me! Some original photos have not been recovered yet.

0 likes

Sign in or create an account to reply. New members are welcome—no purchase or old CT account needed.

calaisturbo.com.au - Manual Conversion-wobble

Who’s online