hey, what is the actual height alowed for a car to be? is it anything that isnt stock height?

lowest point of a car has to be 100 mm above the ground

or a coke can? Some original photos have not been recovered yet.

Well in SA the lowering laws are extremely gay. Lowest point of the car needs to be 10cm off the ground, but the biggest killer is "eyebrow height" which is what I got a nice little sticker for. Now, the front has to have 345mm or more from the center of the wheel to the bottom of the guard lip. What that means is the front basically cannot be lowered AT ALL. However the stupidness comes into play because you can dump the arse end down a good 2.5 inches (295mm is the lowest) and still be totally legal, I dunno who makes these rules, but there's more than enough clearance at the front to allow for lowering.

pack o bs, car cannot b lower than 100mm or 10cm from the ground at n e point! mods lock thread!

wtf are you? what platinum says is true

haha, if it wasn't true than I wouldn't have to deal with all this bullshyte at regency park. btw, this is borderline "too low" (see attached). Some original photos have not been recovered yet.

maybe you dont? maybe its all just a bad dream MODS LOCK THREAD

Quote: Originally Posted by duz360 maybe you dont? maybe its all just a bad dream MODS LOCK THREAD also here is the form fresh from regency (page 2 anyway ). Some original photos have not been recovered yet.

my god you got screwed man.was that done on the roadside?

regency park, it's the government run agency, they are *******s on anything which isn't stock. here's page 1 lol

stereo wiring to be secured every 300mm.lmfao man. that place is some fkn nazi camp

WOW, thats gota suck, would u have got most of that stuff if ur were in VIC. Because i didnt know most of that stuff is bad. QUIKVL

man if your unlucky enough to get a tough cop everything is bad mmmmmmmmkay

in VIC, your car has to be a MINIMUM 100mm off the ground at ANY point, FULLY laiden, eg. 5 ppl in the car

The road clearance of a motor car must not be less than 100mm measured at any part of the vehicle other than the wheel rim or brake backing plates. (This does not apply where a lesser clearance has been specified by the manufacturer.)

platinum... they really bent you over hard didnt they move to queensland, it seems to be the most tolerant state compared to SA, Vic and NSW