hello i need some help with some questions ok well i got the turbo and manifold and (t03 high flow), computer, turbo throttle body and a turbo head. what do i need to get so i can put on the turbo?!?! do i need to get a downpipe or ??? do i need a decomp plate? what else would i need and how much boost will it run??? oh btw it wont have cooler yet. thx alot oh btw will the normal exhaust bolt on the turbo?!?!? im a n00b in this so thx alot maybe a website would be great or something pics thx Some original photos have not been recovered yet.

help please Some original photos have not been recovered yet.

Im guessing your wanting to place the turbo head etc onto a RB30E block?

i got the whole turbo setup but the crossover pipe and i need to know is how do i put it oni just want to know the hard stuff like any problems i will have putting the turbo on and stuff oh btw anyone know where i can get a crossover pipe from?

try the 'for sale' section for a crossover pipe im sure someone would have one lying around

oh another question i heard theres gonna be a problem with hooking up the oil and water or something this true?

If you have a series 2 block and the nessacary parts, no.

ok i got a little problem here on da turbo theres 3 little pipes and 1 bigger one and i know the big one is for the oil and the other 3 are for ??!!?? any help would be great Some original photos have not been recovered yet.

one is the oil inlet, one is for the water inlet and the other is for the water outlet.

but theres 4 pipes 1 is a big one which is oil and the other 3? oh btw where do i hook up the water inlet too and oulet?

Yellow is oil drain back into sump, this will be the big diameter pipe on the bottom of the turbo. Pink is the oil feed to the turbo, this is the smaller of the two banjo fittings. Blue is the water connection, the large banjo fitting Green is the water drain plug and should stay blocked Red is where my water connection is on the other side of the block, someone else will have to confirm this is the std location, this is connected to the long pipe off the turbo, pipe goes to the rear of the block and round the corner to the other side, use the best high temp hose you can find and use good hose clips. Hope this helps Some original photos have not been recovered yet.

Just have to wait for that Sucky 'Webshots' site to get going, should be able to veiw pics in a hour.

UR A F**KING LEGEND!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!

i owe ya one bro!!!!!

exactly wat i needed! i swear bro i really owe ya one !!!!!

i dont know what state you are from but on the gold coast the libary has the referance manual for a vl turbo if your doing a conversion or any work for that matter there very good to have a read of