hey all, my auto of my VLT clunks when it changes gears and also when i drop it down through gears, what is causing this, any advice/info would be greatly appreciated. thanx all Some original photos have not been recovered yet.

It most likely just needs a service. Broken/old gearbox mounts can also make the shifts clunky. if you cant get to the sump bolts under the transmission crossmember without jacking the transmission up, the mounts need replacing... could also be a dead atuo - have it serviced and they'll tell you!

unis and or center bearing. probably not the box itself.

so what can i do about the uni's or centre bearings????

uuummmm...... replace them!

usually is caused due to centre bearings, and uni joints... check if theyre worn, etc.. another possibilty is that ur low on tranny fluid.. just check the level while the cars on... sounds stupid but can be the prob,