please could someone tell me how the hell to run the power cabling through the firewall for my amp? what is the easiest way for the vl? thanks

it depends which side you wish to run the power cabling, you can go through the right handside because there is a hole just above the pedals that is easy to get to from both inside the cabin and the engine bay, ive never tried to run the cable down the left hand side.

Easy...drill a hole wherever there is nothing in the way on either side, put a rubber grommet in and run it through that....

yer man ya best bet is like where the break pad it but up about 10cm, becarefull, i got it first time, but make sure you unplug ya power b4 drilling...................

if the car is an auto there should be a rubber bung where the clutch would go through the firewall. put a hole in that and feed the wire through there.

ahhhhhhh i see, drilling is the way but only in the sweet spot thanks to all those who contributed

if u have a auto then there is a rubber gromet there if u have a manual then there is not and u will have to drill

hey, i know people have said where this grommet is, near the pedals, but i pulled the carpet and underlay back, and buggered if i can find the grommet. i have an auto, but there doesnt seem to be one there. can anyone be more specific about its exact location??

It is about 4cm round and is where the rod on the cluch master cylinder would go. Have a look from the engine bay, you can't miss it.

awesome, found it..i took apart half the dash to run all my wiring, and yep found the grommet...thanks heaps

how big is the cable? maybe u can run it thru the gromets in the wall