Double-coil Rear
31 May 2007Quote: Originally Posted by Benny01 that is the most dangerous thing ive seen in a while Sounds like you need to get out more, Benny, because it aint dangerous at all. The springs & new shocks (Pe…
Built around the cars. Kept alive by the people.

Archived member · original account, not a current login
Quote: Originally Posted by Benny01 that is the most dangerous thing ive seen in a while Sounds like you need to get out more, Benny, because it aint dangerous at all. The springs & new shocks (Pe…
There's an excellent 'short course' on wheel alignment here http://www.familycar.com/alignment.htm - Yes, it is not only possible but very important to have the rear wheels aligned to the body AND the…
Quote: Originally Posted by Calais 902 when i am just crusing down the road on like 1500rpm with my foot just touching the accel pedal it kinda like cuts out then goes again?? as if it was missing o…
Quote: Originally Posted by 87BOOSTA will this work on turbos? You'll get slightly better throttle response but lose fine throttle control. I seriously doubt it will add anything to your power figu…
*Recoils in horror* My eyes! The goggles do nothing! ps. There's a spell checker for IE and Firefox here: http://www.iespell.com/ - If you want people to be able to read and understand your posts, d…
I would guestimate the welding and porting will cost you $150-200 to have a jobbing engineer do it. Dunno whether the XF came out with cruise control, but adding the spring post and extra cable sheav…
Quote: Originally Posted by CAL415 what did you guys use to test, i rekon a few of you have to be a fair whack out I've checked my speedo against a tachymeter (using the 'odo check' km marks on roa…
LOL - GET STUFFED, STOCKY. Sorry, just felt like telling you to get stuffed. 7.5 from a standing start. Hehehee
The Davemobile (NA auto) does 0-100 kph in 6.8 - 7.2 Sec. from a rolling start. Mods: CAI XF TB on ported standard plenum 6-2-1 extractors, stock cat, 2.5" mandrel-bent from the cat back (Redback)…
I scored a spare plenum a few weeks ago and have just got around to welding & porting it properly - I found it was necessary to fill around the neck of the plenum to get the port to full diameter. If…
0 members and 0 guests active in the last 15 minutes
Visitors Today2
33,602 threads, 484,230 posts and 12,881 images saved from CT