Back to shop ↗
THE HOLDEN COMMODORE FORUM

HOLDCOM Community

Built around the cars. Kept alive by the people.

+ Start a discussion
Holden Commodores gathered at Holdcom
Forum Home / Member profile

benau

Archived member · original account, not a current login

40 posts0 discussions

Recent posts

Extractors, be ware

16 Feb 2005

Exhaust before the cat is too hot for most paints, i'm sure nasa would have access to a paint that can withstand that heat. High temp engine paints are intended for engine blocks etc not exhaust heade…

Neutral Switch on a VLT Manual (MX7)

15 Feb 2005

there is a neutral switch on manuals it wires to the ECU it's signal changes the mixture and revs at idle. On an auto the inhibitor switch (P and N start only) is wired to the auto computer and also s…

Fuel Caps

4 Sept 2004

i had a similar experience, I fitted a locking leaded fill cap and a few weeks later I find the outer half of the cap on the ground and the rest was ratteling around inside the fuel tank. luckly they …

Energy Polarizer

1 Sept 2004

Thats right! I remember that one of Brocky's recomendations was to lower tyre pressures with a polariser fitted, and that the polariser would overcome the negative effects of low tyre pressure on hand…

calaisturbo.com.au - Shockers... Towers?

30 Aug 2004

probably better to put a set of adjustable bearing plates in it and have a wheel alignment done if you can fit the bearing plates yourself then budget about $200 for a cheap set and an alignment and a…

calaisturbo.com.au - Shockers... Towers?

25 Aug 2004

a block of wood and a hammer and ur eye for alignment is a quick fix but the bearing plates will also be bent and the tower would have probably bent the replacement u put in. It will pull it back the …

calaisturbo.com.au - 253 petrol question?

25 Aug 2004

if the heads have been done up for gas (gas is dry) then they should have stronger valves and seats than standard heads and so I would think that they would give reasonable service life running unlead…

Who’s online

0 members and 0 guests active in the last 15 minutes

No signed-in members active right now. Guests are welcome to browse.

Visitors Today1

33,594 threads, 484,053 posts and 4,804 images saved from CT

98.1% of indexed threads saved